MLM puch VM18 clamp style intake + PHBG - SQUARE PORT
MLM puch M18 clamp style intake + PHBG - SQUARE PORT
 
  $55.00

 :HERE NOW!!

qty:

 
 
motion left mopeds 18mm clamp style intake for puch and a mikuni vm 18mm carburetor!

you can use this on any puch piston port cylinder using two bolts - stock, treat 50cc, treat 70cc, athena, malossi, metrakit.. whatever!!

square port meaning the opening on the cylinder side is square. this is the one ya want for pretty much every piston port puch cylinder ever, except for the stock hi torque and metrakit cylinders.

this does not fit on stock magnum cylinders as the stud spacing is different

this intake shoots back and to the left.

oh this just in! this intake will also work with a dellorto PHBG clamp style carb with the 1.5mm shim and the spigot style!

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
3 of 5 Not a lot of bang for your buck March 23, 2024
taco eater : John Ryan from MA, United States  
It's alright. A bit too long for my taste. With a Polini CP and air filter, it blocks pedal movement on my Newport. Also, $55 is a hell of a lot for a tube welded to a flange. But hey it works!

Also OD: 23mm... woulda been nice to know

Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 Back and to the left, back and to the left. September 15, 2019
taco eater : robert cain from Indianapolis, IN United States  
Purported to point forwards and to the left but actually points back and to the left...or forwards and to the right. Unless I have my forwards and backwards backwards and forwards this thing shoots out the same as a bing, but lands back further. It appears to point opposite of the round port, why would they do that?

Was this review helpful to you?