MLM puch 15mm SHA intake - ROUND port
MLM puch 15mm SHA intake - ROUND port
 



  $58.00

 :HERE NOW!!

qty:

 
 
motion left mopeds 15mm clamp style intake for use with the any piston port cylinder along with a dellorto SHA.

round port meaning the opening on the cylinder side is round. amazing.

this intake is rear facing.

clamp mount diameter is 19mm for use with sha carbs with a 1mm shim.

bolt holes are approximately 35mm center to center

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Fits on a Garelli Rally Sport! September 24, 2018
taco eater : Alexander Landerman from BLOOMINGTON, IN United States  
With just a little footwork you can get this badest of boys on a Garelli Rally Sport! It's running awesome with the SHA 15mm Carb and takes the hills so much better.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 Expensive but nice September 3, 2016
taco eater : Pacer Racer from Muncie , IN and Louisville, Ky. United States  
Hey this works like a charm on the Garelli NOI motors or cylinders. The tube or runner is off set to the right side of motor but still works. This can be cut and re-welded to a straight forward position if you want. Arch clears frame no problemo. Fits the 15.15 SHA Dellorto with the shim that the carb comes with like a glove. Well made and good fit means it's worth $55. Here now buy now cheap asses.


Was this review helpful to you?

  1 taco eaters like this review
 
4 of 5 pretty much the only sha intake for round port December 23, 2015
taco eater : josh hickman from goshen, IN United States  
sha on metra 65? this is the one. wish the angle was just a hair further from the frame though

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 No more guilt!? April 24, 2015
taco eater : Ben Whittle from Minot , ND United States  
Now I don't need to feel bad about chopping and welding the vm18 intakes to except SHAs for small setups. Hehe

Was this review helpful to you?