|
|
|
|
|
Had to modify |
February 19, 2022 |
taco eater :
Ben Misfit from Detroit, MI United States
|
|
I put this on a Step through Negrini harvard (tube frame bike) with a nos Malaguti expansion chamber. When I mounted it it was only a few inch off the ground and would most definitely scrap on turns. I took it off and cut out a wedge in the back. Then I used some map gas and a vise to close the gap and put a nice upward facing bend on it. Then I welded it. After this it mounted up perfectly. This may mount up differently on a different frame. Over all it's got nice ID's and is a massive upgrade from any stock header I've seen. Getting 41mph on a 42mm PP kit. This is a moped part and with most you have to modify.
Was this review helpful to you?
|
|
|
|
|
|