taco eater :
tom toczek from Lancaster, PA United States
it does what it’s supposed to, bolted up no prob
Was this review helpful to you?
0 taco eaters like this review
good looks, bad luck
June 26, 2016
taco eater :
Blahhhhh from San Diego, CA United States
It looked amazing when it came out of the box. Then I looked at it more and realized the tabs were welded on at a weird outward angle instead of straight. Hmmmm.....ok. Then I went to put it on and because of the weird angle of the tabs, I had to pull the brace and make it wider to fit the tabs on my EBR fork, Then when I finally got it installed, all the powder coat flaked off around the screw holes.
Was this review helpful to you?
0 taco eaters like this review
A little drilling but works fine
May 3, 2016
taco eater :
Chris O'Brien from sandwich, MA United States
I bought these for a 1979 Puch Magnum. Out of the box the holes don't line up with the ones on the stock Magnum forks, but the width is right. Drilled out new holes and it works fine. Definitely stiffens up the forks a bit, not so rubbery anymore.