MLM davinci pipe for puch maxi - angled port
MLM davinci pipe for puch maxi - angled port




motion left puch maxi davinci pipe!!! this model is designed to work with any angled port kit on a puch maxi frame, such as gilardoni, angled eurokit, puch metrakit and more!!

the davinci pipe is a masterpiece of cones previously unseen in prior motion left designs, unleash the full potential of your kit with the magic that lies within davinci's code...or something?

this special design has a stainless steel baffle, a touch of class


Perfect mounting
25mm ID header
super thick mounting flange
18 gauge steel cones
Hand tig welded all around
7 gauge rear mount tab
baffle is held in with a circlip, so this makes changing out packing incredibly easy!! maybe even fun
High temp black powder coat
And....a smile on your face as you blast past your friends

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 6 give your taco rating here

  0 taco eaters like this review
5 of 5 davinci refiew. April 5, 2022
taco eater : David Bixler from South BURLINGTON, VT United States  
I have both the bk100 and the davinci. As others of already noted, I'd pick this one every time! The pipe lined up will! Just remember need wider pedals if you put this or the bk100 on a maxi.

Was this review helpful to you?

  0 taco eaters like this review
5 of 5 Fits a gila maxi perfecto! July 16, 2018
taco eater : jackerz from napa, CA United States  
Can’t say enough good stuff about this pipe.
My gila/tm24 setup on my puch maxi was definitely one of the fastest bikes over the Golden Gate Bridge at the last creatures rally thanks to this rad pipe. Mounted up easy peasy and makes more power than you will know what to do with. If I had a choice between bk100 or this I’d choose the da Vinci every time. I’ve now have had this pipe on 3 bikes and at least 2k miles and it’s still going strong even after laying down my cobra at the races. Favorite angle port puch pipe ever hands down. Also use a crush gasket too, they are the jam!

Was this review helpful to you?

  1 taco eaters like this review
1 of 5 It doesn't fit a Maxi with a Gila. June 7, 2018
taco eater : Aric Aasgaard from Omaha, NE United States  
It doesn't even come close to fitting a Gila on a Maxi.  It is about 1/2 inch up and 1/2 inch out.  If I cut and rewelded the header the bracket still wouldn't work because the chamber would be where the axle is.

Was this review helpful to you?

  1 taco eaters like this review
1 of 5 Be careful. February 27, 2018
taco eater : Marrok Steel from Bonita, CA United States  
Will not fit maxi with MLM magnum swing arm,tomos short pedals/magnum crank.

Was this review helpful to you?

  0 taco eaters like this review
4 of 5 Another good pipe July 7, 2017
taco eater : Andy from Detroit, MI  
Bolted right up on my Gila Pinto with no problems. Quality construction as always. Chamber is almost the exact same size as a Puch Estoril. Pipe is pretty loud but who cares.

One star off because I had to bend the left crank arm out quite a bit to clear the pipe, like enough for pedaling to be a little goofy. It definitely looks like the chamber cones and mounting tab could have been shifted to give half an inch more space but hey, whatever.

Was this review helpful to you?

View All Customer Reviews