MLM clip-on handlebars - 28mm
MLM clip-on handlebars - 28mm
 



  $89.99

 :HERE NOW!!

qty:

 
 
super high quality sleek gloss black clip-on bars made by motion left mopeds in the USA!! these are made for 28mm fork tubes, which are super common for mopeds. make sure you MEASURE!!

OD of your fork tubes has to be 28mm, ok bro?

here are some ebr forks these bars will fit on! just make sure it says 28mm tubes

there is a slight drop to the bars, probably about 15 degrees of drop.

each bar itself is 235mm long or a little over 9" for you standard folks!

normal 7/8" diameter bar. just like your original bars, and every other moped bar im pretty sure

comes with two stainless steel clamp bolts on each bar to tighten the suckers down!!

as usual with motion left products, these are top notch, super durable and sturdy bars that will look super rad on your race bike or whatever you choose to put em on

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
4 of 5 The quality is there but December 16, 2018
taco eater : Countryob from Princeton , MA United States  
These don’t work with 7/8” accessories, the paint is so thick. I’m using a twist throttle from a kx85 1990

And I had to mod the levers to work and for on the bars properly. Other then that these are quality, the welds are butter and you can trust these with your life.

Was this review helpful to you?