MBK av10 malossi PHBG 4 petal reed block intake
MBK av10 malossi phbg 4 petal reed intake block
 
  $90.00

 :*sorry none today*

qty:

 
 
dreamy 4 petal malossi reed valve intake for motobecane av10 engines! carbon reeds no less. mates with dellorto PHBG carburetors. **this is discontinued now**

comes with all the necessary bolts and gaskets and even a special adapter plate!

20 5123

this is an actual 4 petal, the similar polini version has two large petals, while this has 4 petals, 2 to a side. this one is often preferred as the reeds on the polini are riveted on, while the malossi uses screws so you can change the reeds easily to different thicknesses for better low or hi rpm performance.

here are some measurements for all the mods and hackers and people out there..

where the intake bolts to the cylinder:

from center of hole to center of hole dimensions: 39mm x 35mm
there is a bump (ridge) on the intake where it sits on the cylinder, so the dimensions of the width of the bottom of intake and length minus the bump (ridge): 44m x 52mm and the total with the bump: 44mm x 58mm

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Super nice intake November 23, 2013
taco eater : Jesse D from Toronto, ON Canada  
Super great intake, easy to install, great power, looks insane, but it puts the carb tight where your  launch lever would go so if you plan to run one prepare to get creative, a must have for turning your stock av10 into a properly breathing kitted monster!

Was this review helpful to you?