taco eater :
Jacob Fulton from Minneapolis, MN United States
Used this to mount my Polini CP 17.5 to a Pyramid reed 17mm intake.
The material makes a good seal AND has a few mm of stretch for fitment! Just what I needed.
Was this review helpful to you?
0 taco eaters like this review
Better luck with heater hose...
November 4, 2016
taco eater :
Jeremy Bandit from Banditville, KY United States
This thing did okay for a while, but then the hose clamps began eating into the silicone and it all went south. I'm going to back to the heater hose.
Was this review helpful to you?
0 taco eaters like this review
the BEST
September 15, 2014
taco eater :
kyle from oceanside, CA United States
been rocking one of these on my flatreed for a long while now. holds the carb nice and tight, doesnt flop all over and has never come loose or leaked! freakin love these couplers!
Was this review helpful to you?
0 taco eaters like this review
Solid
November 7, 2013
taco eater :
James Bond from Los Angeles, CA United States
It works, I can tell it is high quality stuff. It doesn't stretch or slip.
Was this review helpful to you?
0 taco eaters like this review
THE THUNDER TRIBE
July 16, 2013
taco eater :
zac smith from Seattle, WA United States
I was using some on that double reinvorced clear plastic hose with the braded fiber in it befor to hold my carb on. it would work great as long as the engine was not running, but as soon as it got warm it would get soft and fall off. Then i switched to this bad boy and it holds great and handles any temps. I have put my moby up to 429 degrees and this hold it great.