ATHENA honda DIO performance crankshaft

ATHENA honda DIO performance crankshaft - VERTICAL

ATHENA honda DIO performance crankshaft - 12 pin

$184.99

:HERE NOW!!

qty:

DIO ZX AF18 AF27 AF28 performance athena crankshaft for honda vertical engines found on DIO SR, DIO ZX, 1994 and newer sa50 elite 50 and probably more!!!

NOTE: this uses a 20 x 31 x 7 seal on the variator side whereas the OEM honda crank uses a 19.4 x 31 x 7 seal.

ALSO NOTE: the woodruff key slot is ever so slightly shallower than on the original honda crank. You will need to file/sand down your woodruff key ever so slightly in order to allow the flywheel to properly seat on the crankshaft taper.

41mm stroke
12mm wrist pin
12x17x13 small end needle bearing size

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 1 give your taco rating here

0 taco eaters like this review

amazing value!	September 26, 2024
taco eater : w caldwell from san francisco, CA United States

running this on my af28 dio with much success. extremely well balanced and dropped in with no issues whatsoever. currently running a polini contessa/19 phbg/s6 big valve/pg long/polini ruckus variator with 9:1 gears and have about 1000 miles on the build. runs smooth and vibration free! i'd wager to say this crank is sufficiently strong for 98% of dio builds out there.

much more budget friendly than the malossi RHQ too!

Was this review helpful to you?

treatland