taco eater :
Mariano from Baltimore, MD United States
good clone.. swapped in the 2 stroke atomizer and bushing, and lever choke.. adjustment screws are on the correct side for use with Tomos a55.. unlike what the description says, this carb does not have an oil intake nipple.. mounts real nice to a 70cc airsal kit with the weak-ends a55 19mm intake as long as you cut out about half an inch from the first tall section (https://www.treatland.tv/WEAK-ENDS-intake-p/weak-ends-a55-intake.htm) and the LBM rubber coupler works well (https://www.treatland.tv/LBMopeds-woven-silicone-rubber-mount-for-PHBG-p/lbmopeds-coupler-phbg.htm) .. you can take the throttle cable bendy off of your stock 14mm PHVA top and put on this top for nice cable routing and helps the stock throttle cable length actually open up this slide all the way. tuning takes a bit of work, but i can already feel the low and mid range boost, and with dialed in jetting and taller gearing I'll be blastin..
Was this review helpful to you?
2 taco eaters like this review
Allllllll Blaaaaaaaack! (Well, mostly.)
July 11, 2012
taco eater :
ĦĦĦBlack Demon!!! from Corner of 8th/College, right in front of LJ's
Looks good. All Black. The one screw top and easy access float bowl can't be beat.
Mine came with the 4-stroke atomizer, lucky I've got a couple AUs laying around the gargage and the 2-stroke AU bushing.
What the clone came with: Atomizer size 262, 84 Main Jet, 50 Idle Jet. W6 Needle, clip in one down from top position.
better powder coat than the real PHBG, but this has a 4 stroke AN setup, which the MA wiki says is good for the reed setup I have in mind. also the idle is on the opposite side, perfect for Tomos! get the lever choke and mount it under your stock cover for a sleeper setup