Wrap it a bicycle tube or buy a cheap stick welder
April 21, 2020
taco eater :
Country from Princeton, MA United States
Use an old bicycle tube to get a nice tight fit around the swing arm or but a cheap welder and just do a few tacks
Was this review helpful to you?
1 taco eaters like this review
yeahhhhh idk about these
July 15, 2012
taco eater :
waffles from albany, NY United States
ok well they look sturdy, but the clamp parts are made out of mild steel or something. The clamp tabs just keep bending as you tighten them, so i could not get them solidly clamped on a moby 50v swingarm. If they were made out of a better less malleable steel they would be pretty solid. Prolly get away with some kinda shim and they will be good to go.
Was this review helpful to you?
1 taco eaters like this review
Heavy-duty
February 9, 2012
taco eater :
Jim from Lincoln, NE
I bought these to put on my Magnum. I couldn't get the left side installed due to clearance issues with my Proma Circuit pipe, so I mounted them on my rear shocks instead. While this works, they are a little higher up than I'd prefer and they fold forward rather than up. But, I still like and use them regularly.
Was this review helpful to you?
0 taco eaters like this review
garelli ssxl
February 16, 2011
taco eater :
mac daddy from louisville
These worked great on my 77 garelli ssxl,I did have to drill thru the chain guards to mount up but They look good.They also fold up to get out of the way.If you have a 2 seater do it.they are real solid.Just make sure you bolt on real tight