taco eater :
Goshen Mopeds from goshen, IN United States
a lot of like, maxi N and the canadian maxi S and bombardier puchs use these. mostly obsolete by 1977.
Was this review helpful to you?
0 taco eaters like this review
so far so good
June 17, 2015
taco eater :
Mattman Mopedhead from Oakland, CA United States
I've used the other pedal chain tensioner that treat's sells, the one that looks like the original. that one sux, but this one is looking stronger and more sturdy. Time will tell, but so far I like it.
Was this review helpful to you?
1 taco eaters like this review
Didn't like it too much
September 5, 2014
taco eater :
TRENT from LONG BEACH, NY United States
Didn't like the construction, so removed the gear and hardware from the bottom end being that's what was destroyed on men which was the original. Fits perfecto if you put the chain guide on the outside of the mounting hardware (under te bolt head on one side and under the lock washer under the nut on other side). 4 tacos because it's like mopeds and tacos: mix and match till you find a good thing that doesn't explode your anus.
Was this review helpful to you?
0 taco eaters like this review
It takes some twisting
July 3, 2014
taco eater :
Ken Mullis from Grecia, Costa Rica
Because the front and rear sprocket don't line up exactly it took some twisting and bending to get it to stop throwing the chain. Once the alignment was right it works fine.
Was this review helpful to you?
0 taco eaters like this review
IT WORKS, BUT, YOU MUST TO TURN THE END
August 21, 2013
taco eater :
BURSUCIANU MODEST from MOUNT-ROYAL, QC Canada
I HAVE INSTALL THE ANOTHER ONE WITH RIGID ARM= WRONG ITEM. FORTUNATLY, I HAVE ALSO THIS IN STOCK. IF YOU WANT TO USE AND DO NOT SEE IT GO OVER THE CHAIN, YOU MUST TO TORN THE END IN THE ANGLE OF THE CHAIN. THIS , BECAUSE THE REAR SPROKET AND THE FRONT SPROKET MAKE AN ANGLE. IT IS NORMAL TO TJHIS TENSIONER TO GO OUT BECAUSE IT IS MADE STRIGHT. So, it is your to adjust with a wrench the right direction. also, you may be obligrd to enlarge the space for the chain in the iron clema. you must to add 2-3 metal washers in manner to make inaf space to permit to the chain to work freely in this tenssioner bearing area. i have enlarge the space and the chain go without any problems. I found as thjis is more appropriate than the fix rigid arm one for puch. All the best from Montreal