puch two speed ZA50 CDI box - version II
puch two speed ZA50 CDI box
 
  $17.99

 :HERE NOW!!

qty:

 
 
it's here again! the two speed ZA50 box. this is version II

the high rpm cdi box n 12 volt coil combo for the puch cdi for ZA50, derbi and sachs 505 mopeds

about 2 feet of 7mm spark plug wire included!

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
3 of 5 design failure February 3, 2022
taco eater : mihaly pazar from egg harbor township, NJ United States  
Been using this on 2 different bikes with the supplied cdi party. After just using this as a troubleshooting tool, the wires going into the box itself are to short when produced. all 3 wires now have exposed conductor, the shielding SHOULD have gone another 1/8" into the potting. this is pretty standard ISO standard assembly. since the wires are short the weakest link in the system is the 24-28 gauge copper wire, Obviously made overseas

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 its a lalright coil September 30, 2015
taco eater : tomos guy from bristol, CT United States  
make sure u use the right plug with this coil or u will fry it

Was this review helpful to you?

  0 taco eaters like this review
 
2 of 5 Runs til it doesnt November 20, 2012
taco eater : Moe Phed from USA  
I expected it to die, just not after 40 miles.
Replace it with a cheap scooter CDI for curving/ripping action

http://www.mopedarmy.com/forums/read.php?7,3146255,page=9

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 I used the resistor plug and everything. May 22, 2011
taco eater : Kit Carsick from Fanta Se, NM  
And it still died.  I'll tell ya, though, my magnum was ripping like fuck all when it happened.

Was this review helpful to you?