puch gilardoni 24mm intake by parmakit
puch gilardoni 24mm intake by parmakit
 
  $37.00

 :*sorry none today*

qty:

 
 
24mm intake for the famed 80 gilardoni reed cylinder and other stuff too. use the 24mm rubber mount style OKOs and mikuni carburetors.

brought to you by parmakit

you will have to hack a fin or two to make this work!

these intakes can be used on many different scooters including minarelli V vertical engines. doppler S2R

here's another gasket if you need one

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
2 of 5 port alignment June 3, 2012
taco eater : Anonymous Person from Cambridge, ON Canada  
The port alignment is atrocious, clearly not made for this head. New tabs will need to welded on to make it centered and work to its full potential. Does allow for a tight low pro fit, but otherwise I wouldn't buy it again. Much better options available

Was this review helpful to you?

  2 taco eaters like this review
 
5 of 5 BADDASS!!! May 11, 2010
taco eater : tim ostrom from savannah, GA United States  
if your going to put a mikuni 24 on something. this is the best way to do it. some mounting complications, a little cleanup.

but just sooooo mean looking on a gila.

Was this review helpful to you?