puch airsal EUROKIT 47mm 6 port cylinder kit with head w/flat port exhaust

puch airsal EUROKIT 47mm 6 port cylinder kit with head w/FLAT port exhaust

$169.00

:*sorry none today*

qty:

**THESE ARE NO LONGER PRODUCED, ONLY THE ANGLE PORT VERSION IS AVAILABLE NOW**

way back in the old days of mopedin in another land far far away there existed something known as the EUROKIT 47mm 6 port cylinder.

features:
this is a FLAT PORT cylinder so you can use whatever pipe you want, anything from boss to MLM cali or BK100
20mm round intake port, uses standard puch size intakes, not the smaller size like metra 47mm or larger size like parma
38mm center to center on the intake studs
6 port design - these ports are something to take notes on... side ports are quite impressive!
47mm so you'll have to bore the case to fit
47mm piston with single 1mm ring

need a 100% perfect fitting PHBG intake? for za50 or e50? for clamp style or rubber mount style dellorto PHBG? yes you do don't you. well here you go!

includes : cylinder, head, gaskets, piston, ring, clips, wrist pin.

caution: just like on the 80 metrakits the piston ring will catch on the intake port when you're putting the piston in, so ya gotta know how to handle this man.

caution : just like on the 80 metrakit large port you will need to add some material to your cases to get a good seal on this one cause the transfers are so massive

caution: yeah just caution for now.

grab a replacement piston here!

for further info check this out!

oh and look here, a new review!

introduced 12/21/12 treats production time stamped

taco rating taco rating 5 of 5

5 of 5 Total Reviews: 2 give your taco rating here

0 taco eaters like this review

So Sad	May 30, 2017
taco eater : Andy from Detroit, MI

I grabbed the last one for a case inducted E50. at half throttle, I'm whomping on 70cc kits!

Was this review helpful to you?

1 taco eaters like this review

crazy torque	October 15, 2014
taco eater : Will caldwell from san francisco, CA United States

this kit is amazing. massive torque similar to mk80. transfers are huge...not tall but wide as fuck. had to use a 2mm base gasket to get the piston to clear the exhaust port and lower the compression to make it bump start-able without decomp on a derbi pp motor.

i have this kit on a rigid freespirit on a derbi piston port with a tm24 and modified fasmem pipe. even with crazy tall gearing (24 x 35) off the line = wheelies.

this is the official favorite 47mm kit of treatland employees at the moment.

Was this review helpful to you?