POLINI vespa crankshaft seal, minarelli V1 & morini M1/M01 countershaft seal - 15 x 24 x 5

POLINI vespa crankshaft seal, minarelli V1 & morini M1/M01 countershaft seal - 15 x 24 x 5
 
  $12.99

 :*sorry none today*

qty:

 
 
they are perfectly interchangeable to the original ones, and they can be fitted both on the crankshaft and on the CVT's primary gear. they are made of FKM (fluorocarbon rubber) to better resist to the highest termic stress; the seal lip is made of PTFE (polytetrafluoroethylene); this feature makes them a lot more durable than the standard original ones, giving them a smaller friction coefficient thus granting less heat dispersions caused by the friction and at the same time maintaining lower temperatures. these oils seals have been studied with racing engines but equally they perfectly fit on the standard engines that haven't been tuned-up. more power is produced from the engine as the friction reduction allows it to reach higher revolutions ranges.

1. steel core
2. steel spring
3. blue FKM body
4. brown co-pressed PFTE

teflon and viton oil seals

this POLINI seal is for :

vespa/kinetic crankshaft seal x 2
minarelli V1 output shaft/pedal shaft seal x 3
morini m1/m01 output shaft seal x 1

polini part number 285.0142

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 1 give your taco rating here

  1 taco eaters like this review
 
5 of 5 dope but sensitive August 20, 2014
taco eater : Britton Wilkens from Sonoma, CA United States  
This seal is great, but be careful...it likes to go too deep.  Use you fingers and be very gentle / that sounds funny.

Was this review helpful to you?