oops! i did it again M6 to M8(wow) x 35mm exhaust stud
oops! i did it again M6 to M8(wow) x 35mm exhaust stud
 
  $1.99

 :HERE NOW!!

qty:

 
 
the treats extreme mcagyver m6 to m8 stud. for desperate times or loved kits with too much sentimental value to let go.

oops! i stripped an exhaust stud...then i drilled it out wonky or my hella coil pulled out...noo it's a paperweight! NOT ANYMORE tap that bb to an especially girthy m8 x 1.25mm thread size for crazy times.

good for repairing thread with hella coil or fix a thread, and you will need this stud.

35mm long
m6 x 1.00mm with 14mm of thread on one side
m8 x 1.25mm with 15mm of threading on the other side

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Fix those stripped NU50 stock carbs January 8, 2018
taco eater : captain-janeway from Oakland, CA United States  
Gee if you've ever pulled your stock carb off and on enough that you've managed to pull the studs on the carb off, this will fill the space perfectly.

The carb side is M8, M6 screws it to your bike.

I guess you could actually thread it properly, but I went quick and dirty and put in the 2 ton epoxy I had. Holds fine.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 It lives September 2, 2016
taco eater : Countryobtunning from Princeton , MA United States  
Aww man Now no more worring about blowing out our M6 to m7 studs lol. Be Careful make sure you have enough room and don't go into the exhaust port.

Was this review helpful to you?