|
| |
0 people like this review
|
| |
 |
 |
 |
|
So far, three star |
March 15, 2011 |
| taco eater:
Zachary Kortz
from East Lansing, MI United States
|
|
As you can see in the pic, this kit will need a little massaging. The piston covers the transfer ports by about 4 mm on each side. The transfer ports casting is a little off and will need to be opened up. I would also put some M6 exhaust studs in there. This is not a throw on and go kit, but what do you expect for a Morini kit this inexpensive.
On the good side, the rest of the machining looks good.
I will fix it up, throw it on and see how it runs!
***UPDATE*** I had material added so the base could actually seal to the case. You definitely have to modify the sleeve opening in the case to get this to fit. The piston could use some massaging to ensure the exhaust port opens fully at BDC. My stock head fits with a clearance of exactly 0.5mm between the head and piston at TDC. Should get it running this week.
Was this review helpful to you? 
|
|
 |
|
 |
|
| |
1 people like this review
|
| |
|
|
|
|
|
Sleeve acceptance |
December 3, 2010 |
| taco eater:
Chad Burke
from kalamazoo, Mi
|
|
Just a heads up that for simple slap on of this kit, you will need to have a post 85 morini engine. if it is pre 1985 you will need to have your case bored out to accept this cylinder.
Was this review helpful to you?
|
|
|
|
|
|
|
