minarelli polini 80cc cylinder kit

minarelli polini 80cc cylinder kit
 



  $149.99

 :HERE NOW!!
qty:

 
 
47mm polini V1 minarelli kit includes everything you need - piston, cylinder, rings, wrist pin, clips and gaskets.

would be happy with a 19 or 21mm carb ideally, for precise dudes the exhaust port is 21mm and the intake is 19mm.

this head gasket will solve all your problems if you're running 54mm ID head.

looking for the perfect head to mate this with?

133.0072



taco rating 5 of 5 Total Reviews: 25 give your taco rating here

  0 taco eaters like this review
 
500+ miles deep December 21, 2018
taco eater : tom from Lancaster, PA United States  
Shreds all the way up to 50, temps stay in the mid/high 200s around town

19 phbg
ev turbo
ported/chamfered
case matched
10x40 gearing

Was this review helpful to you?

  0 taco eaters like this review
 
lots of low end torque February 15, 2018
taco eater : Phil from BOCA RATON, FL United States  
Very nice kit. I used the BRN head that was suggested.works fantastic !

Was this review helpful to you?

  2 taco eaters like this review
 
Works well beyond my expectations October 25, 2017
taco eater : Baird from Midway City, CA United States  
Finally bought this for my mutant minarelli motorized race bicycle. I've been blowing up chinese bike motor kits for years, gave up, and got a V1 and built a bike around it.

Got 45mph out of the stock motor after a lot of work, but had no torque.

Installed this kit in under an hour, and couldn't believe the difference! Built it Wednesday,  raced it at the Grange Motor Circuit kart track on Saturday.

No babying it thru a break-in, just full throttle with a 20mm Mikuni and hand-made x chamber. 75lb. "Bicycle," with 24" wheels. 42t sprocket.

Hit 58mph in the 950' straight, and still had more power, just not enough track to hit top speed. Gotta take it out on the street and wind it out.

Easily won my class, even after dumping it with three laps left.

Pulled smooth and fast out of the corners and uphill.

Couldn't ask for a better, easier, faster product.

Now I just gotta learn how to ride my bike all over again...



Was this review helpful to you?

  0 taco eaters like this review
 
Cast Iron is Indestructible November 15, 2016
taco eater : Pat Jack from New Orleans, LA  
You could blow pistons all day and this cylinder will hold up. The only worthwhile slap-and-go kit they make for V1. Get 'em while they last...

Was this review helpful to you?

  0 taco eaters like this review
 
10/10 Motomarina Sebring January 11, 2016
taco eater : Eugene Black from Naples, FL United States  
"SHUT UP AND TAKE MY MONEY!" Pretty much sums it up. After a proper warm up, break in and proper torque settings it just ripped and has had no issues. My Sebring is now a beast and you can feel the increased pull.  Matched with a VM20 (147.5 jet) and smaller rear sprocket it just hauls and I am pushing an easy 40mph cruising speed (190lb, 6'4") with the MLM peoples pipe, ranging between 320-360' temps on 30+ mile daily trips without the V1 cooling fan in Naples, Fl. It has been a pleasure to ride the bike with the additional power. Makes me feel a little safer not being a turtle in the road. #theTOMOSapiens

Was this review helpful to you?

View All Customer Reviews