gilardoni derbi flat reed 50cc cylinder kit
gilardoni derbi flat reed 50cc kit - CI.12.491.G
 
  $140.00

 :*sorry none today*

qty:

 
 
derbi variant 40mm 50cc gilardoni cylinder kit

includes all cylinder, piston, rings, wrist pin, clips, head, base and exhaust gaskets

this is designed for the flat reed derbi engines!

CI.12.491.G

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 pinball 1 March 25, 2015
taco eater : Andrew Grasso from Philadelphia, PA United States  
ran this on my flat reed frankenbike on the first pinball... made it 1600 miles at 50mph before death. yum yum! just like peugeot gila/ puch polini.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 50/50 kit May 19, 2014
taco eater : Ryan M. from Charlotte, NC  
Very pleased with this kit thus far. As stated before, it is fully capable being a 50mph setup with a well tuned carb/vario/pipe. Porting is excellent, third transfer is huge. Revs high and stays relatively cool. After a decent break-in I blasted 100+ mile rally with temps averaging 325-345*. Highest temp was 371*. My only gripe was the stock base gasket was fairly worthless, fits poorly out of the box, but nbd.

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 great kit, needs work to fit on a revo March 27, 2014
taco eater : Ryan Nash from Columbia, MO United States  
great kit.  all around increase in power and top end rpms.  porting is insane on this thing, really reminds me of a puch polini.  easily do 50+ with this and a tuned variator, pipe and carb.  in order to put this on a revo you will have to grind down the back of some of the fins on the left side of the cylinder (looking from skirt side).  it will not clear the revo case otherwise.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Gila on a Derbi = double winning March 23, 2012
taco eater : Derbi Dan from fort lauderdale, FL United States  
Great kit but I needed to mill off a few mm on the bottom of some of the fins to seat properly.

Was this review helpful to you?