|
| |
0 people like this review
|
| |
 |
 |
 |
|
total ripper HOWEVER... |
March 18, 2012 |
| taco eater:
Ryan Nash
from Columbia, MO United States
|
|
you should seriously consider adding the intake booster ports on the piston as well... they are on the cylinder... but not on the piston. c'mon airsal, don't be lazy.
Was this review helpful to you? 
|
|
 |
|
 |
|
| |
0 people like this review
|
| |
|
|
|
|
New ones are NOT Metrakits |
March 15, 2011 |
| taco eater:
Tom
from Sacramento, CA United States
|
|
I just ordered one of these and they are not genuine metrakit ones, I compared it side by side with one I already had and they look like good copies but have several differences. First off it came with an arisal piston, second the "Metrakit" logo is missing from the castings, lastly the quality of the aluminum is worse than the genuine ones. The port map looks the same so I would assume it is still a blaster but it would be nice to not sell them as metrakit cylinders.
Was this review helpful to you?
|
|
|
|
|
|
| |
1 people like this review
|
| |
|
|
|
|
metra 70cc |
January 15, 2010 |
| taco eater:
Anonymous Person
|
|
Got this kit set up on my revolution with a 21 dell. 4 petal reed block and a metra pipe, 60mph. Love it!
Was this review helpful to you?
|
|
|
|
|
|
| |
3 people like this review
|
| |
|
|
|
|
|
metrakit 75cc |
May 19, 2009 |
| taco eater:
Vic
from Portland
|
|
probably the sickest metrakit part available currently.
as a matter of clarification for the part description though:
this kit will not fit on a puch e50 or za50. The kit is setup for a crank with a stroke of 40mm. the standard puch stroke is 43mm.
The other available derbi kits made for the piston port and pyramid reed motor have a 43mm stroke.
Was this review helpful to you?
|
|
|
|
|
|
|
