WEAK-ENDS honda hobbit 28mm INTAKE (for trickMETRIC spacer)
WEAK-ENDS honda hobbit intake for trickMETRIC spacer
 
  $62.00

 :*sorry none today*

qty:

 
 
WEAK-ENDS intake for the honda hobbit trickMETRIC custom reed spacer + dio reed block intake!

27.5mm ID for use with mikuni 24mm and all OKO.

shoots to the right.

grab the perfect length bolts for this intake and the adapter here!

a WEAK-END writes in "as far as clearance on the 24mm stuff if you are a porkchop then you will have to dremel the floor board support tab a little to clear 100% or run beefy shocks. All in all there is very little modding needed to have full travel."

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 3 give your taco rating here

  0 taco eaters like this review
 
5 of 5 Great design July 11, 2013
taco eater : Shane Beers from Chicago, IL United States  
Pairs perfectly with the trickmetric riser. I have aftermarket, but stock length, shocks on my hobbit, and set to the stiffest preload. No stretching, no subframe swapping, no funny euroboizzzz length rear shocks. Puts the TM24 in a slightly clumsy position on the right side of the bike and interferes with pedals if you run a filter. I just threw pegs on there and called it a day.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 8) November 15, 2012
taco eater : Naash Wiley from Ames, IA United States  
SO GOOD

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 QUALITY stuff September 12, 2012
taco eater : Ryan M from Charlotte, NC United States  
Just got mine yesterday. Awesome quality & fitment. Oh and the welds look way better than if I did em. A+ product design.

Was this review helpful to you?