WEAK-ENDS honda hobbit INTAKE (for trickMETRIC spacer) - PHBG
WEAK-ENDS honda hobbit intake for trickMETRIC spacer - PHBG
 



  $62.00

 :*sorry none today*

qty:

 
 
WEAK-ENDS intake for the honda hobbit trickMETRIC custom reed spacer + dio reed block intake!

21mm ID for use with dellorto spigot style PHBG.

shoots to the right.

grab the perfect length bolts for this intake and the adapter here!

a WEAK-END writes in "as far as clearance on the 24mm stuff if you are a porkchop then you will have to dremel the floor board support tab a little to clear 100% or run beefy shocks. All in all there is very little modding needed to have full travel."

taco rating taco rating 4 of 5 4 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
5 of 5 pipe March 19, 2014
taco eater : Shawn Hellebuyck from Bay city, MI United States  
Solid intake, bolted directly to trickmetric spacer with VForce3 reeds (reeds need altering). THe carb will clear your pedals but with an air filter of any size pedals and filter collide. no big deal.

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 must be hard to measure properly March 3, 2013
taco eater : Anonymous Person  
the holes didn't match up by the smallest amount with my trickmetric

Was this review helpful to you?