TOP crankshaft needle bearing - 12 x 15 x 15
TOP crankshaft needle bearing - 12 x 15 x 15
 
  $9.99

 :HERE NOW!!

qty:

 
 
needle bearing for crankshaft con rod. size is 12 x 15 x 15 mm.

a common size used by many a moped and other motor bikes.

for all puch mopeds and tomos A35 + many more, check the size.

wallaroo, buxy, buxy RS, zenith, squab, vivacity, speedake, SV50, speedfight, elyseo SP electr. SPX, fox, velofax, zundapp 3, 4, 5 v, FS1, DT50MX, RD50MX, derbi GPR/senda

*please note: you can not put this in a stock crank that originally has a brass bushing*

taco rating taco rating 5 of 5 5 of 5 Total Reviews: 4 give your taco rating here

  0 taco eaters like this review
 
5 of 5 The Proper Part June 13, 2012
taco eater : Tora Tora from San Francisco, CA United States  
Bats Approved
http://www.bayareatwostroke.com

This is the little end bearing to employ on the Derbi EBE050 and EBS050 engines (GPR, Senda).

Whenever refreshing anything in the top end we replace the little end bearing with one of these. The price is fantastic, and we are getting reliability at engines that run at ~14K rpm.

Was this review helpful to you?

  0 taco eaters like this review
 
4 of 5 Fits Morini May 13, 2011
taco eater : Zachary Kortz from East Lansing, MI United States  
Used this to replace my Morini wrist bearing, better quality than stock

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 replaced my dmp crank needle bearing with this October 1, 2010
taco eater : Will Caldwell from San Francisco, CA United States  
the top needle bearings seems to be a lot better than the stock on e that comes with the stuffed/unstuffed dmp crank. Needle bearings take a lot of abuse and you should consider replacing them often, because when they fail, bits of needle bearing completely destroy your fancy top end.

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 Good quality, wont work with stock. May 20, 2010
taco eater : Anonymous Person from Cincinnati, OH United States  
Does not fit in stock puch crank.

Was this review helpful to you?