puch moped front sprockets
puch moped front sprocket
 
  $8.99



puch front sprocket size



qty:  
 
 
puch E50 + ZA50 front sprockets for regearing your moped to your needs. you may need to recut your chain depending on your gear selection. no biggie

we carry these sizes in the drop down menu bar - 10, 11, 12, 13, 14, 15, 16, 17 and 18!

if your looking to go even bigger like 19, 20 or 21 look here!

taco rating taco rating 4.5 of 5 4.5 of 5 Total Reviews: 8 give your taco rating here

  0 taco eaters like this review
 
4 of 5 Saul good November 27, 2021
taco eater : Moped Madman from Murrieta, CA  
It works, nothing magical, the A+ quality fit a little better but its only a peice of metal with teeth, save ten bucks and dont let it bite ya when your throwing it on

Was this review helpful to you?

  1 taco eaters like this review
 
2 of 5 Loosey Goosey July 15, 2020
taco eater : Matt B from Troy, NY United States  
The stock front sprocket is nice and tight fitting, the more expensive ones are nice and tight fitting, these are loose, with lots of play back and forth and maybe are a bit thinner so the retaining clip rotates freely while its on, its probably fine but it will cause more wear to the spline because of this, its just a fact... low tolerances

Was this review helpful to you?

  0 taco eaters like this review
 
5 of 5 For the 18 tooth May 27, 2016
taco eater : Countryobtunning from Princeton , MA United States  
Make your Dremel and file your best friend. Took me about 20 mins to slap it on a modern 3 bearing case. I got scared, I though I went to deep but it end up being a threaded hole for a magneto screw thank god!

Was this review helpful to you?

  1 taco eaters like this review
 
5 of 5 yesssss March 6, 2016
taco eater : daev o. from Providence , RI United States  
slapped a 17t on my e50 mag and it went on in less than 2 mins. weighed about same as stock 16t. and when I paired it with 41t rear OHHH NOOOO so fast its scary.... buy this and enjoy!

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 Too big for an e50 January 29, 2016
taco eater : Wesley Brown from Austin, TX United States  
I couldn't get the 18 to fit on an e50 even after grinding down the case.  Build quality is pretty killer though.

Was this review helpful to you?

View All Customer Reviews