well, lets face it if you get this and slap it onto your 505/1a, b,c, or d your going to run into some issues, however it can be done. step 1- carbon reeds, duh. step 2-drill and tap that clutch spline. step 3- get an mvt premium cdi on there. step 4- get a 7 peice clutch step 5- aluminum motor mounts step 6- regear step 7- destroy everyone
but if your running a 2 speed, or a three speed like myself, get ready for instant insanity. also, port this if you can.
Was this review helpful to you?
2 taco eaters like this review
wow
October 14, 2010
taco eater :
Will Daloz from Atlanta, GA United States
I use this for high speeds and sadness. it makes for lots of failures. destroyed a crank with it already, blew up the clutches too. I founf the best fix is to drill and tap a set screw into the clutch toothed gear piece so it's locked to the crankshaft.
also hot.
Was this review helpful to you?
1 taco eaters like this review
RRRRRRRRRRrrrr
May 28, 2010
taco eater :
MBartell from Eugene, OR United States
Good quality kit, only minor clean up needed on the jug itself. Lots of power, lots of vibration, it broke the flywheel off my crankshaft. Further research needed.
Was this review helpful to you?
4 taco eaters like this review
AHHHH !
November 23, 2009
taco eater :
Graham Motzing from Milwaukee, WI United States