treatland.tv

 

  puch gilardoni 21mm PHBG dellorto intake by TOP
  Puch Gilardoni intake 21mm PHBG dellorto
 
  $30.00


 :HERE NOW!!

 
 
21mm PHBG dellorto intake for the famed 74cc gilardoni kit. this one made by TOP

use the 21mm rubber mount style dellorto PHBG usually designated DS or the race edition, could use 19mm too...but WHY?

pretty dreamy on 1 speeds, run your clutch cable around the carb. but on 2 speeds you won't be able to run it to the right(clutch cable interference foul play)...so ya gotta cut some fins to use it on the twosies, hangin left.

this intake is not made for puch gilardoni, but with some dremel work you can make it work. you will have to dremel out the mounting holes a bit and dremel air + gas opening to match the gilardoni. once you got it. it works quite well on an E50.

these intakes can be used on many different scooters including minarelli V vertical engines.


taco rating  give your taco rating here

  0 people like this review
 
THIS THING SUCKS November 29, 2011
taco eater: Ricky from Providence, RI  
I just came back because i was reminded how fucking shitty this stupid intake is. The casting was fucking terrible, I had to dremel so much out of it to even make it match the intake port at all. Fuck whoever made this peice of garbage.

Was this review helpful to you?

  0 people like this review
 
This thing sucks. February 24, 2011
taco eater: Ricky CGFY from Providence, RI  
DOES NOT bolt right on. need to dremmel for it to fit onto the kit, bolt holes arent aligned. and the port on the engine side doesnt match the reed black. Just annoying to buy something built for a kit and it doesnt even fit.

Was this review helpful to you?