The sealing surface on the edges is sooooo narrow, used a combo of RTV and gasket paper to seal it. Quality welds for sure.
Was this review helpful to you?
0 taco eaters like this review
noice
February 22, 2016
taco eater :
UPJET DOOV from Brooklyn, NY
This thing rules. Got a malossi 4 pedal block with the stuffer and a gila intake drilled out to 19mm. Throttle response is insane now! However, I ran into one issue... with everything bolted up the little horizontal frame brace above the motor mount was resting on the intake. No problem though, I just cut away a bit of the offending frame and it's all good.
Was this review helpful to you?
0 taco eaters like this review
I NEED TO HAVE THIS
February 17, 2016
taco eater :
Shingledoo from Boston, MA
ya gotta get these back in stock I can't believe I blew it and didn't buy it when it was in stock but I didn't even know ugh wtf please devin/treats make these again I want to throw my lomat into a fire it's so so so bad.
Was this review helpful to you?
0 taco eaters like this review
Sweet
February 11, 2016
taco eater :
Buttcheeksbuzzard from Sumter, SC United States
About time somebody made it! Throw out your shitty cast, aluminum, holes aren't drilled right, threads strip out, piece of shit lomat out and replace it with this! It's 15937671 times better.
Was this review helpful to you?
0 taco eaters like this review
If you want to know what reeds fit this...
February 10, 2016
taco eater :
Tommy Rollek from Charlotte, NC United States
VFORCE for gila fits these, it's the same block. This is a direct copy of the lomat.