taco eater :
Richard Ensor from Syracuse, NY United States
Iv'e tried this intake on my authentic 15mm and 12mm bing carbs and it doesn't want to go on. I have a 12mm clone from Amazon and it fits that perfectly.
Was this review helpful to you?
0 taco eaters like this review
Built to last
September 20, 2019
taco eater :
Mattylite from Stamford, CT United States
Tough to get on, but boy does it look nice. Spray the filter part down with some air filter oil and put some thread locker on the main screw so ya don't loose it! Paired it with the MLM clamp, so it even looked cooler, but could have used cheapo hose clamp. I'd rather it look nice.
Was this review helpful to you?
0 taco eaters like this review
Fits my Maxi Luxe
February 25, 2019
taco eater :
Pacific Racer Youtube from Tacoma, WA United States
It fits my Maxi Luxe pretty tight. It just needed a few light smacks it get it on right.
Was this review helpful to you?
2 taco eaters like this review
Rad!
October 16, 2017
taco eater :
Anonymous Person from Pacifica, CA United States
Awesome air filter. Fits on Maxi perfectly with frame rails. The air filter is not symmetrical. ROTATE it to make it fit. If you have problems making it fit you might have other problems as well.
Did not have to sand out the inside. Just pry it open a bit before installing.
Was this review helpful to you?
0 taco eaters like this review
Good intake, but needs modification
May 20, 2017
taco eater :
Frosty from Charlotte, VT United States
defiantly a good little intake, but the stupid black paint should be masked off where the intake mounts to the carb when MLM painted them. Other than the sanding I had to do, it was an easy bolt on with a cheap hose clamp.