6203 ST snap ring bearing for top & metrakit crankshafts
6203 ST bearing top metrakit crankshafts
 
  $27.99

 :HERE NOW!!

qty:

 
 
this is the special snap ring bearing for top & metrakit crankshafts and also found on korado cranks as well

for the 1984 and later original crankshafts (with needle bearing and both 17x40x7 seals) and compatible remake crankshafts like top and metrakit

the inner race on the side opposite the outer clip groove is recessed by 1mm

this bearing does NOT come with the snap ring piece as of now but has the groove for it, sooo....

get the snap ring for this bearing hereeeeee!

replaces puch part # 900.6254

6203 ST - 17 x 40 x 12

taco rating taco rating 3.5 of 5 3.5 of 5 Total Reviews: 2 give your taco rating here

  0 taco eaters like this review
 
4 of 5 ALSO FOR STOCK CRANK W/ NEEDLE BEARING August 1, 2015
taco eater : Maxwell Shapiro from Evanston, IL United States  
The later year Puch engines (with the needle bearing and 3 shoe clutch) also require this special bearing for the stock crank.

Was this review helpful to you?

  0 taco eaters like this review
 
3 of 5 It works September 30, 2011
taco eater : Taylor Duncan from Columbus, OH  
I got this bearing for my Korado motor. I measured the inner race at 10 thousands too thick as compared to the stock bearing, but it wasn't a deal breaker. It did require chamfering of the edge of the securing snap ring ever so slightly so it would do it's job and snap in place. Expensive, but a problem solver for sho.

Was this review helpful to you?