taco eater :
Mike Boyd from Los Angeles, CA United States
Like they say, measure first!
Was this review helpful to you?
0 taco eaters like this review
To: Mills...
September 23, 2015
taco eater :
Terencio Safford from St. Paul, MN United States
Yo Mills, can you elaborate on using nuts on the inside and outside of the forks? PM me if that is possible.
Was this review helpful to you?
0 taco eaters like this review
Perfect for Pacer spoked
May 6, 2014
taco eater :
Sean Berg from Washington, DC United States
These fit perfectly in the rear hub of my stock Pacer SS spoked wheels, no shims necessary. Got the Puch 12mm sealed axle, and that atomic rear wheel spacer is the perfect length too! Sealed bearing rear spoked easy as pie.
Was this review helpful to you?
0 taco eaters like this review
Fits perfect into Snowflake front wheel
April 17, 2014
taco eater :
Michael Santos from San Francisco, CA United States
Huge improvement over the loose bearing setup. Bearing fit perfectly into the cup without the use of a shim. Just make sure to press them all the way in because they'll get tight and act as if they're all the way in when in fact they are not.
Was this review helpful to you?
0 taco eaters like this review
Wheel bearing and tomos gear cluster bearing
March 22, 2014
taco eater :
Weak-Ends TJ from Port Saint Lucie, FL United States
Not only is this for making wheels sealed, it is also the same bearing that the rear of the gear cluster rides on in the a35/a55 case.
+1 for front Puch Snowflake wheel 
