19mm x 1mm and 26 x 1.5 flywheel magneto puller for minarelli CEV + MBK le partie cdi + peugeot malossi cdi +puch+derbi+ moreee
19mm x 1mm flywheel magneto puller
 
  $13.50

 :*sorry none today*

qty:

 
 
19mm x 1mm and 26mm x 1.5mm flywheel magneto puller for many different applications including peugeot malossi CDI flywheel & the le partie mbk cdi

also use for some minarelli, garelli (cev no 6412 among many others!), tomos a3 (cev no. 6436) magnetos, some morini dansi. other CEV magnetos, minarelli AM6 and aprilia RS50.

check what size you need

taco rating taco rating 2 of 5 2 of 5 Total Reviews: 1 give your taco rating here

  0 taco eaters like this review
 
2 of 5 Won't thread into the flywheel January 2, 2015
taco eater : Eric from Rochester, NY United States  
I bought his for Puch (bosch) and minarelli (cev 6932) flywheels. Both are 19mm x 1mm. This puller will only thread in about one thread and then binds up. The threads on the puller aren't cut deep enough. I tried this on 3 flywheels with the same issue. Off to find a 19mm die so that I can chase the threads. I already ground the end of the bolt down so that it centers on the end of the crank instead of mushrooming the crank (because it comes flat). Honestly, I should have just made one myself since I have to buy a die to fix it anyway. Unless you already have a large metric die set, save yourself some money and buy one of the other pullers on here.

Was this review helpful to you?